Products

The most widely used EPS foam boards for ETICS contact insulation systems.

To ensure simpler logistics, we replace base and corner boards with a solution where only base boards are used and these are glued on the sides with slats of facade mineral wool. These slats with a thickness of 30 mm and a length of 1,000 mm are always available in a width according to the thickness

In the course of 50 years of use, white insulation boards have gained a firm place on construction sites due to their excellent utility properties.

Stabilized boards for thermal insulation of structures with high load requirements.

Stabilized boards for thermal insulation of structures with normal load requirements.

Stabilized boards for thermal insulation of structures with normal  load requirements.

Contact diffusion open film with _d ≤ 0.03 m, possibility of laying directly on insulation and formwork.

Contact diffusion open foil with_d ≤ 0.025 m, possibility of laying directly on the insulation, roll width 1,500 mm.

Black ALU tape, tape width is 90 mm, 100 m in one package.

Black single-sided adhesive tape with high resistance to UV radiation and excellent adhesive properties.

The corner joints of the plates are reinforced with fire-fighting screws with a length equal to twice the thickness of the insulation in the case of square pipes.

Isover Acoustic SSP2 boards are laminated on one side with black non-woven glass fabric.

A new generation of MW insulator systems for the heat-insulating assembly of flat roofs made of vertically oriented mineral fibers.

A new generation of MW insulator systems for the heat-insulating assembly of flat roofs made of vertically oriented mineral fibers.

A new generation of MW insulator systems for the heat-insulating assembly of flat roofs made of vertically oriented mineral fibers.

Isover Domo Plus rolls are suitable for any heat and sound insulation construction.

Basalt wool boards for insulation of wooden buildings and prefabricated structures.

Mineral facade plugs are used for recessed installation of dowels.

Glue for gluing the face of the insulation layer adjacent to the fire separation structure.

Intumescent sealant for covering the perimeter of the fire seal at the point where the air duct passes through the fire separation structure.